Hitachi 42PD5000 User Manual page 58

00 42型スピーカー統合-五校 03.9.9 3:39 PM ページ2
Caution
Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red)
before you connect or disconnect the speaker cables.
Attach the speaker systems to the monitor.
Attach the speaker brackets to the speaker systems.
1
Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L).
In the case of (R)
Speaker holder
screw X 2
Attach the speaker systems to the monitor.
2
Remove two screws on each side of the monitor
as shown and keep them for re-install. Loosen
two screws on each side of the monitor as
shown so that the speaker holders can be slide
on to them. Insert the loosened screws into the
engaging holes of the speaker holders that are
attached to the speaker system, and slide the
screws downwards. Next, use the previously-
removed screws to fasten the speaker holders
into the mounting holes in the monitor. Tighten
the four screws to secure.
Attach the connection cables to
3
the speaker system.
Treating the wire ends
Pull off while twisting
Please prepare the supplied
speaker cables.
How to connect
the speaker
cables
(Speaker side)
Caution required
Be sure to insert the speaker cables securely.
Lock the connection terminal level securely.
(R)
screw X 2
R
L
Speaker
holder
Cushion
Right side
Loosen
screws
Monitor rear side
Speaker terminals
Connect the copper-coloured
+
wire to the side
Connect the silver-coloured
wire to the - side
Press down Insert the Remove
the lever with wire your finger
your finger
(L)
Notice
Use of cushions
In some cases, there can
be a gap between the main
unit and the speaker. You
can attach the cushions
provided to the side of the
speaker system, if desired,
to eliminate the gap.
Speaker holder
shown the other side
Remove
screws
スピーカー端子
(6Ω12W)
Hook this section
on the loosened
screw
Attach the speaker connection
4
cables to the monitor.
スピーカー端子
(6Ω12W)
Connect
（ ）
the silver-
colour wire
How to connect
Press the
the speaker
lever down
cables
(Monitor side)
Cushion
Attach the cushions
to the sides of the
speakers facing the
main unit.
Align the cushions
to the front of the
back case and affix
them.
Back case
Remove
SPEAKER TERMINAL
(8Ω8W)
screws
- +
Black Red
スピーカー端子
(6Ω12W)
スピーカー端子
(6Ω12W)
Connect
（ ）
the copper-
colour wire
Raise the
Insert the
lever
wire