Mounting The Speaker Unit - Hitachi 32PD7800 User Manual

INSTALLATION INSTRUCTIONS (continued)

Mounting the Speaker Unit

CAUTION
Make sure that the main power swich of the monitor is turned off (standby or indicating lamp: off/red) when removing or connecting the
speaker cables.
Mounting the Speaker System to the Monitor
1. Mounting the Speaker System to the Monitor
Hook the clamps (3 pieces) into the holes as shown in the figure,
and pull them down.
Follow the step in both Right and Left sides.
CAUTION
Make sure to use the speaker systems fastened with the speaker
holders and the screws.
2. Attach the speaker holders
After twisting the screws off as shown, fasten the speaker system to the monitor with the speaker holder by the screws.
The speaker holder direction is opposite on the Right and Left speaker systems.
Right Side
Twist off
the screws
Rear of the monitor
3. Attach the speaker connecting cables to the monitor. (Make sure the ferrite core is toward the monitor side)
Treating the wire ends
Pull off while twisting
Please prepare the supplieol
speaker cables
Monitor
Speaker
System
Speaker holder
Screws x 4
Speaker holder
Screws x 4
Place to attach the side input.
Ferrite core
How to connect
the speaker
cables
(Moniter side)
Clamps
NOTE
In case that the speaker
systems do not fit with
the monitor body's
height.
When loosen the screws
fixing the aluminum pieces,
the speaker system is
movable up and down.
Adjust the position to the
monitor body's height, then
tighten up the screws.
(R) (L)
Black Red Black Red
Connect the Connect the Connect the Connect the
silver copper silver copper
colored wire colored wire colored wire colored wire
Press down Insert the wire
the lever
Right Side
Rear of the monitor
Aluminum pieces
Ferrite core
Raise
the lever
Screwdriver
17