Back to Contents Page
Power Button Module
Dell™ Inspiron™ 620 Service Manual
Removing the Power Button Module
Replacing the Power Button Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING:
Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
Removing the Power Button Module
1. Follow the instructions in
Before You
2. Remove the computer cover (see
3. Remove the front bezel (see
4. Disconnect the power button module cable from the system board connector, LEDH1 (see
5. Press the power button module tabs and pull the power button module to release it from the front panel.
1 power button module 2 power button module tabs (4)
6. Set aside the power button module in a secure location.
Replacing the Power Button Module
1. Follow the instructions in
Before You
2. Align and push the power button module tabs into the slots on the front panel.
Begin.
Removing the Computer
Cover).
Removing the Front
Bezel).
Begin.
System Board
Components).