Indoor Unit Installation Drawings - Daikin Quaternity FTXG09HVJU Engineering Data

Installation Manual

Indoor Unit Installation Drawings

1.
Removing and installing indoor unit.
• Installation method
1) Using the
indoor unit, attach the
onto the indoor unit.
2) Attach the tabs on the bottom frame onto the
mounting plate. If the tabs are not hooked onto
A
the plate, remove the front grille to hook them.
(Check to see if the tabs are hooked securely.)
• Removal method
Push up the mark part on the bottom of the front
grille, discharge the tabs, and then remove the unit
while lifting it up.
Mounting plate fixing
K
screws 3/16" × 1"L (M4 × 25mm) (9)
Front panel
1-15/16" (50mm)
or more from walls
(on both sides)
Titanium apatite
C
photocatalytic
air-purifying filter
22
marks (3 locations) on top of the
mounting plate hooks
A
The A mounting plate
should be installed on a
Mounting plate
A wall which can support the
weight of the indoor unit.
Supporting plate
Supporting plate
1-3/16" (30mm)
or more
The securing tape is applied.
from ceiling
Be sure to remove it before
installation.
Air filter
Mounting
A
plate
Bottom
frame
Mark
(rear side)
To remove the unit, push up the bottom of the bottom
Tab
frame with your fingers to free tabs.
(Mark parts (2 locations) on the bottom of the front grille.)
How to open the service lid
The service lid is
removable.
Use when
opening the
front panel and
securing.
Install the
hose with a
downward
slope.
Deodorizing filter
B
for streamer
Set the
dry batteries
G
AAA. LR03
(alkaline)
Fixing screws for remote
L
controller holder
1/8" × 13/16"L (M3 × 20mm) (2)
EDUS04-906
Mounting
A
plate
Opening the lid
1) Remove the screws
2)
on the service lid.
2) Hold the knobs on the
service lid and pull
forward.
1)
Cut thermal insulation pipe
to an appropriate length and
wrap it with tape, making
sure that no gap is left in the
insulation pipe's cut line.
Wrap the insulation
pipe with the finishing
tape from bottom to top.
Wireless
E
remote controller
F
Hook
Remote
controller holder
Before screwing the
remote controller
holder to the wall,
make sure that control
signals are properly
received by indoor unit.
Room Air Conditioners H-Series
3