Advertisement
Energy DMX™
Energy DMX™
Locate and remove the unit's power cord. Once the cord has been
removed locate the fuse holder inside the power socket. Insert a flat-
head screwdriver into the power socket and gently pry out the fuse
holder. Remove the bad fuse and replace with a new one. The fuse
holder has a built-in socket for a spare fuse be sure not to confuse the
spare fuse with active fuse.
American DJ
www.americandj.com - Energy DMX™ Instruction Manual Page 11
©
® -
DMX Traits
Fuse Replacement
Energy DMX™
Strobe Lamp Warning! This fixture is fitted with a
strobe lamp which are highly susceptible to dam-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
cian. Replace with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp or fuse and you con-
tinue to blow either one, STOP using the unit. Contact customer sup-
port for further instructions, you may have to return the unit for ser-
vicing. Continuing to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Again, please remem-
ber to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling strobe
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the six phillips screws that run along the bottom sides of
of the unit (three on each side).
3. Seperate the base and the cover.
4. Unscrew and disconnect the three wires from the PCB.
Remember which wire went where.
5. Push the lamp holders out to remove the lamp.
6. Remove and replace the lamp with an exact match. Remove the
silicon wire covers from the old lamp, and use them to cover the
new lamp wires'.
7. Connect the three wires to the correct points on the PCB.
8. Reassemble in reverse order.
For illustrated instructions on how to replace the lamp, see the
next page.
American DJ
www.americandj.com - Energy DMX™ Instruction Manual Page 12
©
® -
Lamp Replacement
techni-
®
Advertisement
