Fuse And Lamp Replacement - American DJ DJ Spot 300 User Instructions

DJ Spot 300
This fixture is fitted with a halogen lamp which is
highly susceptible to damage if improperly han-
dled. Never touch the lamp with your bare fingers
as the oil from your hands will shorten lamp life.
Also, never move the fixture until the lamps have
had ample time to cool. Remember, lamps are
not covered under warranty conditions.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a slide out socket assembly that is retained by thumb screws.
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the two small screws (A,B) on the rear of the unit
3. After removing the screws, gently slide out the socket assembly
from the rear of the unit to expose the lamp.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
6. After replacing the lamp follow the optimization procedures on the
next page to be sure the lamp is center in the reflector
A
American DJ - www.americandj.com - DJ Spot 300 Instruction Manual Page 17
© ®
Fuse & Lamp Replacement
service
®
B
DJ Spot 300
GOBO REPLACEMENT:
1. To change the gobos, you must remove the bottom half of the
moving head. The bottom half of the moving head is were the fan
is located.
2. Unscrew the four phillips screws, that secure the bottom half, and
remove.
3. When you remove the bottom half, the gobo and color wheel will
now be accessible. Turn the wheel with your hand until you find the
gobo you would like to change. Turn the color wheel until the emp-
ty space is behind the gobo you would like to change.
4. Remove the gobo fixation-ring with a small flat-head screwdriver.
Put your finger through the empty space in the color wheel, and
push the gobo out towards the front. When doing this you do not
need a lot of pressure. You can also use tweezers to gently pull
the gobo out, or a small flat-head screwdriver and gently pry out
the gobo.
5. Change the gobo, replace the fixation-ring, and reassemble the
unit.
Fuse Replacement: Locate and remove the unit's power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
American DJ - www.americandj.com - DJ Spot 300 Instruction Manual Page 18
© ®
Gobo Replacement