Lamp Replacement; Fuse Replacement - American DJ Vizi Roller Beam 2R User Instructions

Vizi Roller Beam 2R
Channel Value
14
128 - 159
160 - 191
192 - 223
224 - 255
15 0 - 255
16 0 - 255
17
0 - 225
226 - 235
236 - 245 BLACKOUT BY WHEEL CHANGING
246 - 255
18 LAMP ON/OFF, RESET & PROGRAMS
0 - 19
20 - 29 COLOR CHANGE TO ANY POSITION
30 - 39 COLOR & GOBO CHANGE TO ANY
40 - 59
60 - 79
80 - 84
85 - 87
88 - 90
91 - 93
94 - 96 SHUTTER/DIMMER MOTOR RESET
97 - 99
100 - 119
120 - 139
140 - 159
160 - 179
180 - 199
200 - 219
220 - 239
240 - 255
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 52
18 Channel DMX Mode
Function
SHUTTER & STROBE
PULSE EFFECT IN SEQUENCES
SHUTTER OPEN
RANDOM STROBE SLOW - FAST
SHUTTER OPEN
MASTER DIMMER 0% - 100%
FINE DIMMER INTENSITY
PAN/TILT MOVEMENT SPEED
MAX TO MIN. SPEED
BLACKOUT BY MOVEMENT
NO FUNCTION
COLOR CHANGE NORMAL
POSITION
LAMP ON
LAMP OFF
ALL MOTOR RESET
SCAN MOTOR RESET
COLOR MOTOR RESET
GOBO MOTOR RESET
OTHER MOTOR RESET
INTERNAL PROGRAM 1
INTERNAL PROGRAM 2
INTERNAL PROGRAM 3
INTERNAL PROGRAM 4
INTERNAL PROGRAM 5
INTERNAL PROGRAM 6
INTERNAL PROGRAM 7
SOUND ACTIVE PROGRAM
Vizi Roller Beam 2R
Caution:
Always replace with the exact same type lamp and fuse, unless
otherwise specified by an authorized ADJ service technician. Replacing
with anything other than the specified part can damage your unit and will
void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the unit.
Contact customer support for further instructions, you may have to return
the unit for servicing. Continuing to use the unit may cause serious damage.

Lamp Replacement:

Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp. Please see page 7 for important information regarding the
discharge lamp. Do not handle the lamps with with bare hands!
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the three small screws (labeled A, B, & C) on the bottom
of the unit.
3. After removing the screws, gently remove the lamp access panel.
4. Carefully disconnect the two wires connected to the lamp (Pic A).
5. Next, located on the left side squeeze the lamp holding clips
togther and lift the holder (Pic B).
6. Replace the lamp with an exact match. Reassemble in reverse
order. Clear the lamp time after replacing the lamp.
Pic A
Fuse Replacement: Locate and remove the unit's power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 53
Lamp Replacement
Pic B