Section 4: Power; Powering Up The Minimax - Honeywell miniMAX Quick Start Configuration Manual

4.1

POWERING UP THE MINIMAX

1. Remove the front cover(s) of the HMX32128 video subracks and remove the packing
cardboard from the subracks. Replace the front cover(s).
2. Connect the power cords from the video subracks (HMX32128) to the HMXPS9
power supply using the supplied cables.
3. Connect the power cord to the HMXAT200 and HMXPS9 and plug them into a good
earth grounded outlet.
4. Place the power switch on the front of the HMXPS9 Power Supply in the ON
position.
5. Check that all 8 amber indicator LEDs on the front of the HMXPS9 are illuminated (2
LEDs per output). An extinguished LED indicates a problem on the corresponding
output (1, 2, 3, or 4). Disconnect the corresponding power cable from the equipment
and check the device.
6. Remove the front cover from the HMXAT200 System Controller.
7. Depress the red power switch to turn the System Controller power on.
The System Controller will automatically load the default system configuration
from the hard-drive.
8. Camera number 1 will be displayed on Monitor number 1.
Rev. 1.0
SECTION 4:
POWER
11 900.0688
9-Dec-05