Henny Penny 580 Maintenance Manual page 9

1. Drain the shortening.
2. Remove the high limit bulb holder from the heating
element.
3. Remove the Control Panel.
4. Disconnect the heating element wires from the contactors.
5. Loosen the screws on the element spreaders.
6. Slide the element spreaders to the back of the heating
elements.
7. Remove the brass nuts and washers which secure the ends
of the elements through the cookpot.
8. Remove the heating elements from the cookpot as a group
by lifting the far end and sliding them up and out toward
the rear of the cookpot.
Always install new
rings when installing
heater elements, or shortening may leak inside cooker.
9. Install new heating elements with new rubber "0" rings
mounted in the center of the stacked elements.
10. Replace the heating elements, terminal ends first at
approximately 45" angle, slipping the terminal ends
through the front wall of the cookpot.
11. Replace the brass nuts and washers on the heating element
terminals.
12. ove the element spreaders from the back of the elements
to a position which will spread each element apart evenly
on all four sides, and tighten.
13. Replace the high limit bulb holder on the top element, and
position on the bulb above the top element and tighten
screws which hold bulb in place.
14. Reconnect the wires to the appropriate terminals.
15. Replace the front control panel.
16. Connect the power cord to the wall receptacle or turn wall
circuit breaker on.
Heating elements shou nergized without
shortening in the cookpot, or damage to heating
elements could result.