Chrysler Sebring Convertible 2010 Owner's Manual page 276

ESC Malfunction Indicator Light
The "ESC Malfunction Indicator Light" in the
instrument cluster will come on when the
ignition switch is turned to the ON position. It
should go out with the engine running. If the
"ESC Malfunction Indicator Light" comes on continu-
ously with the engine running, a malfunction has been
detected in the ESC system. If this light remains on after
several ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater than 30 mph
(48 km/h), see your authorized dealer as soon as possible
to have the problem diagnosed and corrected.
NOTE:
• The "ESC Off Indicator Light" and the "ESC Malfunc-
tion Indicator Light" come on momentarily each time
the ignition switch is turned ON.
• Each time the ignition is turned ON, the ESC system
will be ON even if it was turned off previously.
• The ESC system will make buzzing or clicking sounds
when it is active. This is normal; the sounds will stop
when ESC becomes inactive following the maneuver
that caused the ESC activation.
ESC Operating Modes
All ESC equipped vehicles can choose the following ESC
operating modes:
ESC On
This is the normal operating mode for ESC. Whenever
the vehicle is started the ESC system will be in this mode.
This mode should be used for almost all driving situa-
tions. ESC should only be turned to "Partial Off" for
specific reasons as noted below.
Partial ESC Mode
This mode is entered by momentarily pressing the "ESC
Off" switch (located in the lower switch bank below the
heater/air conditioning controls). When in "Partial Off"
mode, the TCS portion of ESC, except for the limited slip
STARTING AND OPERATING 275
5