Download  Print this page

Kenmore Gas Wall Oven Installation Instruction Page 3

Gas wall oven.
Hide thumbs

Advertisement

2. Connect
Electricity
to Gas Wall
Oven
For personal
safety,
these appliances
must be
properly grounded.
This appliance is equipped with a three-
prong grounding plug for your protection against shock
hazard and must be plugged directly into a properly
grounded receptacle. Do not cut or remove grounding
prong from this plug.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Preferred
Method
Grounding
type wall
receptacle
Do not,
underany
_
circumstances,
cut,
I
remove, or bypass
I
the grounding
/
prong.
/
J
Power supply cord with
3-prong grounding plug
Figure 2
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation
of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances,
cut or remove the
third
(ground)
prong from the power
cord.
If an external electrical source is used, the appliance,
when installed, must be electrically grounded in
accordance with local codes or in their absence of local
codes with the National Electric Code ANSI/NFPA No.
70-1987 or latest edition.
3. Alternate
construction
(Model with 11/2oven cavity only)
Installation Instructions for installing a 11/2 cavity oven into
an existing 2 cavities opening with dimensions 42-1/8"
height by 22 1/2"Width.
ght
adjuster
Wood
runner
Hywood
filler
Figure 3
,
If width opening is too wide to secure unit to cabinet
with mounting screws, add plywood filler strips.
,
If height opening is at 42-1/8",
lower height adjuster
1 " (see section 4) and secure two 2" X 4" X 22"
wood runners on each side at bottom of opening (see
figure 3).
, The decorative lower trim (not shown) can be
installed to hide the gap under the unit. It should
overlap by 1/4" the front of the cabinet at bottom of
cutout (see step 2 of section 5).
Check all code rules and regulations for connecting the
wall oven to be certain the installation conforms with all
local, municipal and state codes as well as local utility
regulations.
Failure to comply with the above could result in a
serious shock hazard.
Note: All hook-ups and adjustments shall be performed
by qualified technicians.
Disconnect electrical supply cord from
wall receptacle before servicing wall oven.
3

Advertisement

Table of Contents

This manual is also suitable for:

Gas wall oven

Comments to this Manuals

Symbols: 0
Latest comments: