Craftsman 919.167630 Owner's Manual page 15

Before Each Start-Up
1. Place On/Auto/Off switch to "Off".
2. Pull regulator knob out, turn
counter-clockwise until it stops.
Push knob in to lock in place.
3. Attach hose and accessories.
NOTE: The hose or accessory will
require a quick connect plug if the
air outlet is equipped with a quick
connect.
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
use damaged or worn accessories.
hazardous risk of bursting. Check
the manufacturer's maximum
pressure rating for air tools and
accessories. The regulator outlet
pressure must never exceed the
maximum pressure rating.
Compressed air from the unit may
contain wa ter condensation and
oil mist. Do not spray un fil tered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the in struc tions for the air
tools and accessories.
Risk of unsafe
operation. Firmly
Risk of unsafe
operation. Do not
Too much air
pressure causes a
Risk of unsafe
operation.
How to Start
1. Turn the On/Auto/Off switch to
"On/ Auto" and allow tank pres-
sure to build. Motor will stop
when tank pressure reaches "cut-
out" pressure.
2. Pull the regulator knob out and
turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place. The compressor
is ready for use.
operate the air compressor in well-
ventilated areas free of gasoline
or other combustible vapors. If
the compressor is being used to
operate a sprayer DO NOT place
near the spray area.
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
15 - ENG
Risk of fire or
explosion. Always
If any unusual
noise or vibration
1000002924