lifeSMART LS-4W1500-X Owners Installation And Operating Manual page 7

Definitely NOT! If you don't have a grounded outlet, contact a certified electrician for advice.
Removing or altering any part of the heater's original design or intent (including the power cord) will
not only void the warranty, but will make you liable for any unexpected or hazardous results.
This is completely normal. The temperature display on your heater may vary from the temperature
display on another thermostat (like the one mounted to your wall or a purchased external
thermostat). The temperature sensor on your heater reads the temperature in, and around, the
heater. The unit is near the cold floor (and heat rises), which in turn, will display a cooler temperature
than elevated or external thermostats. The best way to operate your heater is just to set the unit on
"High" and dial up to a temperature that feels comfortable to you. Then, leave it at that temperature,
regardless of the mismatch. The heater will cycle off when the set temperature is met or exceeded
slightly.
Definitely NOT! If you don't have a grounded outlet, contact a certified electrician for advice.
Removing or altering any part of the heater's original design or intent (including the power cord) will
not only void the warranty, but will make you liable for any unexpected or hazardous results.
The answer to these is the same. Yes. You will be able to use it, but keep in mind that
rooms/structures with open floor plans, minimal insulation, adjacent rooms, or high ceilings will not
retain the heat as efficiently, and may not feel pronounced heat changes. Also, the heater will stay on
longer (delays the "off" cycle), and may increase your electric costs. Note that if you do use it in a
garage or basement, the moisture levels must be very low and they must have dedicated circuits (15
amps minimum) with no GFCI outlets. If unsure what a GFCI outlet is, contact a certified electrician.
Yes. But make sure they are not plugged into the same circuit. Each heater (heaters are considered
appliances) requires its own minimum 15 amp circuit (with no other items plugged into that
circuit). If unsure your circuit meets these requirements, verify with a certified electrician. Risk of
fire, damage to property, or injury may result if requirements are not met.
This is normal. The heater's fan will continue to run, even after the heater automatically cycles
down. The fan continues to run so that every last bit of heat is blown out of the heat chamber, while
allowing the unit to continue filtering your air. Once the internal box/components cool completely, the
fan should then shut off on its own.
7