Page 1
NOTE: Please read all instructions carefully before using this SPACE DOME product GD-810 Table of Contents Safety Notice Hardware Identifier Assembly Instruction Parts List Warranty Ordering Parts Model GD-810 Retain This Manual for Reference 121005 OWNER'S MANUAL ® IMPEX INC.
ORDERING PARTS..................… BEFORE YOU BEGIN ® Thank you for selecting the Space Dome GD-810 by IMPEX . For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
WARNING LABEL PLACEMENT The warning label shown here has been placed on the frame. If the label is missing or illegible, please call customer service at 1-800-888-8899 for replacement. Apply the label in the location shown.
IMPORTANT SAFETY NOTICE This play ground equipment is built for optimum safety. However, certain precautions apply whenever you operate a piece of play ground equipment. Be sure to read the entire manual before you assemble or operate your equipment. In particular, observing the following safety precautions and warnings to reduce the likelihood of serious or fatal injury.
Page 5
CONSUMER INFORMATION SHEET FOR PLAYGROUND SURFACING MATERIALS The U.S. Consumer Product Safety Commission (CPSC) estimates that about 100,000 playground equipment- related injuries resulting from falls to the ground surface are treated annually in U.S. hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have the potential to be fatal, particularly when the injury is to the head.
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: One Adjustable Wrench and one Allen Wrench NOTE: It is strongly recommended two or more people assembling this equipment to avoid possible injury. STEP 1 (See Diagram 1) A.) Attach two Blue Frames (#1) to the upper two holes on a 6-hole Bracket (#5). Attach two Blue Frames to the lower two holes on the same 6-hole Bracket.
Page 8
Step 2 (See Diagram 2) A.) Attach five Yellow Frames (#2) to a 5-hole Bracket (#4). B.) Secure each Yellow Frame to the Bracket with one M8 x 5/8” Allen Bolt (#6), Ø 5/8” Washer (#7), and M8 Aircraft Nut (#8). C.) Do not tighten the Nut and Bolt yet.
Step 3 (See Diagram 3) A.) Connect a Blue Frame (#1) to a 4-hole Bracket (#3) and secure them with one M8 x 5/8” Allen Bolt (#6), Ø 5/8” Washer (#7), and M8 Aircraft Nut (#8). Do not tighten the Nut and Bolt yet.
Step 4 (See Diagram 4) A.) Connect two lower beams on a Frame-A (Blue) to the 4-hole Brackets (#3) on Frame-C. B.) Secure each hole with one M8 x 5/8” Allen Bolt (#6), Ø 5/8” Washer (#7), and M8 Aircraft Nut (#8).
Page 11
Step 5 (See Diagram 5) A.) You should have five Blue Frames (#1) left by now. B.) Connect the five Blue Frames (#1) horizontally to the opening holes on the 6-hole Brackets on the top. C.) Now set the entire unit firmly on the ground and align all the frames. Make adjustment if necessary.
® IMPEX INC. LIMITED WARRANTY ® IMPEX INC ("IMPEX ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of 2 YEARS from the date of purchase. This warranty extends only to the original purchaser.