Hunter ceiling fan Installation And Operation Manual page 11

Uninstalling the Light Fixture
1. To uninstall the light fi xture, fi rst disconnect the plug connectors
between the black wire and the black/white wire.
2. Disconnect the plug connectors between the two white
wires.
3. Uninstall the nut and washer from the end of the light
fi xture inside the lower switch housing.
4. Unscrew the threaded rod of the light fi xture from the
lower switch housing.
5. Remove the light fi xture from the lower switch housing
pulling disconnected wires through the hole in the center
of the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through fi rst, and then pull the other
plug connector (female) through the hole.
6. Install the dummy terminals (included in the sack parts)
on the two disconnected wires in the lower switch
housing.
7. Install the switch housing cap and plug button to the
lower switch housing.
8. Continue with step 7-6 on page 12.
Male Dummy
Female Dummy
Terminal
42607-01 • 02/16/06
Terminal
Cap
Plug Button
Lower Switch
Housing
 readed
Rod
Steps 3 – 5 Steps 3 – 5
Step 7
Hunter Fan Company
11