Thermador PH30 Care And Use Manual page 6

CARE AND CLEANING
To Clean Hood Surface
For general care, wipe the outside of the stain-
less steel with sudsy water or household clean-
ers such as Fantastic ® or Formula 409 ®, rinse
well and dry with a clean soft cloth to avoid
water marks.
• Wipe and dry stainless steel in the same
direction as the grain. Avoid using too much
pressure, which may mar the surface.
• Do not use abrasive products such as steel
wool.
To remove finger prints and give added shine,
use a stainless steel cleaner such as Stainless
Steel Magic(D, Hadco Stainless Steel Polish,
Sprayway(D Stainless Steel Polish and Cleaner,
or 3M Stainless Steel Cleaner and Polish.
• Do not allow any cleaning compounds to remain
in contact with stainless steel for extended
periods.
The use of brand names is intended only to indicate
a type of cleaner. This does not constitute an
endorsement. The omission of any brand name
cleaner does not imply its adequacy or inadequacy.
Many products are regional in distribution and can
be found in the local markets. It is imperative that all
products be used in strict accordance with instruc-
tions on the package.
To Clean Filters and Troughs
Your hood has removable aluminum filters, stainless
steel grease troughs and stainless steel side panels.
They must be cleaned when the filter light illumi-
nates on the control panel or whenever they collect
grease. When used over a grill, wok or other high
grease applications, more frequent cleaning may be
required.
To Remove Filters and Grease
Troughs:
• Turn the
cool and
• Remove
1.
2=
3=
fan and lights off. Be sure filters are
grease has congealed before removal.
in the following order:
Filters -Start with center filters, push
up, then pull out from the bottom.
Side Panels - Remove these the
same way as the filters.
Grease Troughs - lift up and out.
The filters and grease troughs can be washed by
hand or in the dishwasher. The front and side
panels may be washed with warm soapy water
and polished with stainless steel cleaner.
Reverse the above directions to reinsert the trough,
filters and side panels.
Thermedor
@@@ @ @
1 2 s
ooo oo 06
OFF FAN DELAY FILTER LIGHT HEAT LAMPS
SPEED SHUT OFF
Figure 2
Note: Do not use cooktop while hood is disas-
sembled. Grease troughs must be in place before
installing the aluminum filters.
000 O0 O0
Side Panel
_,2 Filters _2
Filters
Side Panel
Grease Trough
Figure 3
Note: Depending upon the size and model of hood,
there will be anywhere from 1 to 3 filters per hood.