Connector Configuration - Albatron KX400-8XV User Manual

Connector Configuration

Front Panel Indicator: SW/LED、PWRLED
1
2
3
PWRLED
+
1
-
3
-
5
+
7
9
SW/LED
Pin Assignment Function Pin Assignment Function
1
HD LED (+)
3
HD LED (-)
5
RST SW (-)
7
RST SW (+)
9
NC
HD LED (Hard Drive LED Connector)
This connector can be attached to an LED on the front panel of a computer case. The LED will
flicker during disk activity. This disk activity only applies to those IDE drives directly attached to the
system board.
RST SW (Reset Switch)
This connector can be attached to a momentary SPST switch. This switch is normally left open.
When closed it will cause the mainboard to reset and run the POST (Power On Self Test).
PWR-LED (2-pin Power LED Connector)
The mainboard provides two power LED connector.If there is a 2-pin power LED cable on the front
panel of a computer case. You can attach it to the 2-pin power LED connector. The LED will
illuminate while the computer is powered on.
PWR SW (Power on Switch)
This connector can be attached to a front panel power switch. The switch must pull the Power Button
pin to ground for at least 50 ms to signal the power supply to switch on or off (the time required is
due to internal debounce circuitry on the system board). At least two seconds must pass before the
power supply will recognize another on/off signal.
PWR-LED (3-Pin Power LED Connector)
The mainboard provides two power LED connector. If there is a 3-pin power LED cable on the front
panel of a computer case. You can attach it to the 3-pin power LED connector.
+
NC
-
+
2
-
4
+
6
-
8
10
2
Hard Drive
4
LED
6
Reset
8
Switch
10
NC
14
KX400-8XV V2.0 Series
ACPI LED (+) POWER
ACPI LED (-) LED
PWR SW (+) Power-on
PWR SW (-) Switch
NC NC