Screen Setup - Samsung SHR-6080 User Manual

using the DVR

Screen Setup

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR,
depending on the condition. Then, you can change the display position of the data.
3. In the <Device> window, press the up/down (▲▼) button
to move to <Monitor> and press the [ENTER] button.
4. Select the <Monitor> item.
5. Select <Display Position Setup> in the bottom.
You will move to the <Display Position Setup> window.
6. Use the four direction buttons or the number buttons on
the front panel or the remote control to adjust the data
position.
Setting the Spot Out
You can set the DVR to output information / video apart from the monitor out.
Using the mouse may help easy setup.
3. Use the up/down buttons (▲▼) in <Device> window to
move to <Monitor>, and press [ENTER] button.
4. Select <Spot Out>.
Use direction buttons (▲▼◄ ►) to move to a desired
5.
item, and set the value.
•
Spot Out1 : You can select between 16-, 9-, 4-split, Auto
Sequence, and Single.
•
Set Mode : A window for "Set Spot Out" appears and you
can set the channel for it.
You can set the dwell time between the screen switching in
"Setting the Device > Camera> SEQ-Dwell Time".
(Page 42)
•
Event Display : Sets the duration for the Spot Out on an
event.
If selected <OFF>, an event will not output to the Spot Out.
M

You can setup using the mouse right button in Live screen.
Refer to "Spot Out". (Page 31)
6. When the Spot Out is done, press <OK>.
48_ using the DVR
Display Position Setup
30
30
30
OK Cancel
Monitor
Spot Out
Monitor Mode
Set Mode
Spot Out 1 16-split
Set Mode
Set Mode
Set Mode
Event Display OFF
OK Cancel
Monitor
Spot Out
Monitor Mode
Set Mode
Spot Out 1 16-split
Set Spot Out
Set Mode
Set Mode
1 2 3
Set Mode
5 6 7
9 10 11
13 14 15
Event Display OFF
OK
OK Cancel
30
ALL
ALL CH
CH 5,6,7,8
CH 9,10,11,12
4
CH 13,14,15,16
8
12
16