Fs' Reset To Factory Settings - Zektor HDA800 User Manual

Response String:
There is no response string to the SS command, this command is write only.
Where 'settings' is a bitmapped parameter defined as:
32768 16384
Value
15 14
Bit
Bit-0
Bit-1
Bit-2
Bit-3
Bit-4
Bit-5
Bit-6
Bit-7
Bit-8
Bit-9
Bit-10
Bit-11
Bit-15
Note: The HDA800(V2) must be powered on before sending the "Save HDMI settings" (Bit-15).

'FS' Reset to Factory Settings

This command will reset selected parameters of the HDA800(V2) to their factory default settings.
This command uses a bitmapped parameter to indicate which values are to be reset. A bit set to '1'
indicates the associated setting should be reset, a bit set to '0' indicates the setting should not be reset
and the previous setting will remain unchanged.
Command formats:
^FS settings$
Response String:
There is no response string to the FS command, this command is write only.
Where 'settings' is a bitmapped parameter defined as:
32768 16384
Value
15 14
Bit
Bit-0
Bit-1
Bit-2
Bit-3
Bit-4
Bit-5
Bit-6
Bit-7
Bit-8
Bit-9
Bit-10
Bit-11
Bit-15
44
8192 4069 2048 1024
13 12 11
- Save zone input/output mappings, and power state
- Save switch delay times set by the 'DZ' command
- *Reserved*
- Save control settings (the 'XS' command settings)
- *Reserved*
- Save IP parameters and settings ('IPA' , 'IPM' , 'IPG' , and 'IPSET' settings)
- *Reserved*
- *Reserved*
- Save zones' volume settings
- Save zones' audio parameters (bass, treble, eq, mute level, zone gains, zone lipsync, etc. all but volume)
- Save source audio parameters (input gains, input lipsync delay)
- Save global audio parameters (master volume, volume and mute fade times)
- Save HDMI settings: EDID and HDCP caches, HDCP key counts, and the EDID lock state.
8192 4069 2048 1024
13 12 11
- Reset zone input/output mappings, and power state
- Reset switch timings (the 'DZ' command settings)
- *Reserved*
- Reset control settings (the 'XS' command settings)
- *Reserved*
- Reset IP parameters
- *Reserved*
- *Reserved*
- Reset zones' volume settings
- Reset zones' audio parameters (bass, treble, eq, mute level, zone gains, zone lipsync, etc. all but volume)
- Reset source audio parameters (input gains, input lipsync delay)
- Reset global audio parameters (master volume, volume and mute fade times)
- Reset HDMI settings: Clear EDID and HDCP caches, clear HDCP key counts and the EDID lock state.
512 256 128 64
10 9 8 7 6
Reset the parameters indicated by 'settings'
512 256 128 64
10 9 8 7 6
HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
Advanced Control
32 16 8 4 2
5 4 3 2 1
32 16 8 4 2
5 4 3 2 1
1
0
1
0