Table of Contents
Advertisement
The response string of the 'IPG' command is not the current gateway address of the HDA800(V2), but
the gateway address that will be used the next time the 'IPSET 0' command is issued. To retrieve the
current IP address of the HDA800(V2), use the read only command 'IPGX' (See: "'IPGX' Retrieve
the current IP gateway address in use" on page 48.)
'IPAX' Retrieve the current IP address in use
This command is read only and will return the IP address being used by the HDA800(V2). If DHCP is
being used, this will return the address given to the HDA800(V2) by the router. If static mode is being
used, this will return the static address currently in use by the HDA800(V2).
The command format is:
^IPAX ?$
Response String:
^=IPAX xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
'IPMX' Retrieve the current IP mask in use
This command is read only and will return the IP mask being used by the HDA800(V2). If DHCP is
being used, this will return the mask given to the HDA800(V2) by the router. If static mode is being
used, this will return the static mask currently in use by the HDA800(V2).
The command format is:
^IPGX ?$
Response String:
^=IPGX xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
'IPGX' Retrieve the current IP gateway address in use
This command is read only and will the gateway address being used by the HDA800(V2). If DHCP is
being used, this will return the address given to the HDA800(V2) by the router. If static mode is being
used, this will return the static address currently in use by the HDA800(V2).
The command format is:
^IPGX ?$
Response String:
^=IPGX xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
48
Read the current IP address
= IP address in standard form (Ex: 192,168,001,200)
Read the current IP mask
= IP mask in standard form (Ex: 255,255,255,000)
Read the current TCP/IP router address
= Gateway address in standard form (Ex: 192,168,001,001)
Advanced Control
HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
Advertisement
Table of Contents
