Command Syntax; Command Responses; Type Of Responses And Timing Information; The Acknowledgement Response - Zektor HDA800 User Manual

Command Syntax

Command Syntax
The HDA800(V2) serial command set uses an ASCII based protocol and a terminal emulator can be
used to test the serial port of the HDA800(V2).
Each serial command is formatted as:
^CMD param1,param2,...$
Where:
^
CMD
param
$
For instance the name of the command to turn power on / off is '
turn on the HDA800(V2) send:
^P 1$
^+$
^=P 1$
to turn off the HDA800(V2) send:
^P 0$
^+$
^=P 0$
N : Only the characters between '^' and '$' are valid, any characters sent before the '^' or after the '$'
OTE
will be ignored.
N : By default, the HDA800(V2) adds a carriage return and a line feed to the end of its responses, after
OTE
the '$'. This makes testing with terminal software easier. Since they are outside the '^' and '$' char-
acters, they should be ignored by software drivers. If desired, this behavior can be disabled. (See:
"'XS' Control Settings" on page 41)

Command Responses

Type of Responses and Timing Information

There are three different types of responses: Acknowledgements, Errors and Query Strings.
By default, the HDA800(V2) will always respond to a command, there are no "time-out" modes, if you
send a command and don't get a response within 100ms, something's wrong with the connection.

The Acknowledgement Response

Every command will be followed by an acknowledgement or error response.
Anytime you issue a command and there are no errors, you will receive the acknowledgement
response. Which is:
^+$
HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
= All commands and responses start with the '^' character.
= The name of the command.
= Any number of parameters can follow a command.
= All commands and responses end with the '$' character.
Command sent to the A/V switch
->
Acknowledgment indicating valid command
<-
Response from the A/Vswitch for new setting
<-
Command sent to the A/V switch
->
Acknowledgment indicating valid command
<-
Response from the A/V switch for new setting
<-
Command Syntax
' (must be capitalized) therefore, to
P
29