Changing The Ip Address - Zektor HDA800 User Manual

Changing the IP Address

IP Mode: [STATIC]
Addr: 192.168.001.200
By default the switch uses DHCP to acquire an IP address, to change this to static:
If the LCD display is not at showing the main menu press the MENU button.
Use the SELECT knob to select the "IP Setup" option: Setup > IPSetup
Press the SELECT knob to select the DHCP setting, then use the knob to change this to STATIC.
Press the SELECT knob again to switch to the static mode.
Use the SELECT knob to scroll to the [Addr:] option, press the SELECT to enter the update-mode.
The SELECT knob can now be used to scroll between the [Addr:], [Mask:] and [Gate:] options,
allowing you to change the static IP address, the IP mask and the IP gateway parameters.
To change any of the parameters, select the parameter you want to change (address, mask, or gate-
way), and press the SELECT knob. Scroll to the octect you want to change, select it, and change it.
Hint: The selection knob uses acceleration to allow faster updating of values. To make large
changes in the values, spin the knob quickly. For precise changes, spin the knob slowly.
The IP address changes are not made until you scroll to [OK], and select it. You can ignore any of
the changes you've made by pressing the MENU button before selecting [OK].
Once you select [OK], the IP address changes will be made and they will be saved in EEPROM so
that they will be retained through a power failure.
16
MENU
SELECT
OK
BACK
HDA800(V2) User Guide, Version 1.3, 9/12/13
Using the Front Panel
ZONE
SETTING
NEXT