'IPA' Set / View the static IP Address
This command does not immediately change the TCP/IP address. It sets up the static IP address that
will be used the next time the 'IPSET 0' command is issued.
The command format is:
^IPA xxx,xxx,xxx,xxx$
^IPA ?$
Response String:
^=IPA xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
The response string of the 'IPA' command is not the current IP address of the HDA800(V2), but the IP
address that will be used the next time the 'IPSET 0' command is issued. To retrieve the current IP
address of the HDA800(V2), use the read only command 'IPAX' (See: "'IPAX' Retrieve the current
IP address in use" on page 48.)
'IPM' Set / View the static IP Mask
This command does not immediately change the TCP/IP mask. It sets up the static mask that will be
used the next time the 'IPSET 0' command is issued..
The command format is:
^IPM xxx,xxx,xxx,xxx$
^IPM ?$
Response String:
^=IPM xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
The response string of the 'IPA' command is not the current IP mask of the HDA800(V2), but the IP
mask that will be used the next time the 'IPSET 0' command is issued. To retrieve the current IP mask
of the HDA800(V2), use the read only command 'IPMX' (See: "'IPMX' Retrieve the current IP
mask in use" on page 48.)
'IPG' Set / View the static IP gateway address
This command does not immediately change the TCP/IP gateway. It sets up the TCP/IP gateway
address that will be used the next time the 'IPSET 0' command is issued.
The command format is:
^IPG xxx,xxx,xxx,xxx$
^IPG ?$
Response String:
^=IPG xxx,xxx,xxx,xxx$
Where:
xxx,xxx,xxx,xxx
HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
Set new TCP/IP address
Read the current TCP/IP address
= IP address in standard form (Ex: 192,168,001,200)
Set new TCP/IP mask
Read the current TCP/IP mask
= IP mask in standard form (Ex: 255,255,255,000)
Set new TCP/IP router address
Read the current TCP/IP router address
= Gateway address in standard form (Ex: 192,168,001,001)
Advanced Control
47