Adjusting The Projected Image Height - BOXLIGHT Projector User Manual

6.6 Turning off the projector
1) Press Power and the "Press Power again to turn off the lamp!" message
appears.
2) Press "Power" again to turn off the projector (the message will disappear
automatically after 5 sec if the power button is not pressed again).
3) The lamp turns off and the Power LED indicator blinks rapidly. The fans
continue to run for 60 seconds to cool down the projection lamp. During this
cool down sequence the projector will not respond to any user input.
4) When the fans stop and the Power LED starts flashing slowly, you can either
turn the projector back on or set the power switch to "o" and disconnect the
power cord.
Note:
To extend the lamp life-span, please do not unplug the power cord
immediately after the lamp is turned off. Please allow at least 120 sec for
the fan to stop, and then you can unplug the power cord.

6.7 Adjusting the projected image height.

To adjust the angle of the projector
To raise the projector
1. Press and hold the Adjustor-foot release button.
2. Raise the projector to the height you want, then release the button to lock the
foot into position.
Adjustor-foot release button
Adjustor-foot
14