Storage - Breville BKC600XL User Manual

BR9013 BKC600XL_IB_AMEND.qxp
Care and cleaning
The Brewer will continue to operate even when
the LCD screen indicates 'DESCALE'.
However, if you do not descale the Brewer soon after
it is displayed, continued scale build-up could
damage the Brewer. If this occurs, 'DESCALE' will
begin to flash, alerting you to the potential damage to
the Brewer if you do not descale immediately.
Promptly follow these steps each time the LCD
screen indicates 'DESCALE' to ensure the Brewer
functions optimally.
1. Empty the Water Tank.
2. Pour 60 oz. of vinegar into the Water Tank, filling to
just below the top edge of the clear viewing area.
3. Place a 12 oz. or larger ceramic cup (do not use
a plastic cup) on the Drip Tray. The Drip Tray and
Drip Tray Plate can be removed to accomodate
taller mugs and travel mugs
4. Select the largest brew size (11.25 oz. serving)
by pressing the
5. Run a cleansing brew without a K-Cup ® (refer to
Brewing Hot Water, page 15). Pour the contents
of the cup into the sink.
6. Repeat the cleansing brew process until the
Water Tank is empty, pouring the contents of the
cup into the sink after each cycle. Remember
to raise and lower the Safety Locking Arm
between each cycle so the control panel
buttons illuminate.
7. Let the Brewer stand for at least 4 hours while
still on.
8. Rinse the Water Tank thoroughly and fill with
fresh water.
9. Place a 12 oz. or larger ceramic cup (do not use
a plastic cup) on the Drip Tray.
10. Run a cleansing brew without a K-Cup ® (refer to
Brewing Hot Water, page 15). Pour the contents
of the cup into the sink.
24
11/10/07 21:43
continued
Note
button on the control panel.
Page 24
11. Repeat the cleansing brew process until the
Water Tank is empty, pouring the contents of the
cup into the sink after each cycle. You may need
to perform additional rinse cycles if you notice
any residual taste. Remember to raise and lower
the Safety Locking Arm between each cycle so
the control panel buttons illuminate.
12. The machine is now ready for use.
If the LCD screen continues to indicate
'DESCALE' after completing the process, repeat
the process above.

Storage

Before cleaning or moving the Brewer to a different
location, ensure the Brewer has been turned off.
Switch off at the wall outlet, unplug the power cord
and allow the machine to cool. The Water Tank
should be emptied and dried thoroughly.
• Store your Brewer in its upright position to avoid
water leakage from the inner tank.
• Store your Brewer in a frost free environment.
Storing the Brewer in a cold environment runs the
risk of water freezing inside the Brewer and
causing damage. If your Brewer has been stored in
an environment below freezing, ensure to let it
warm to room temperature for at least 2 hours
before using.
• When preparing to use the Brewer after storage,
we recommend rinsing the Water Tank with fresh
water and running three cleansing brews without
a K-Cup ® (refer to Brewing Hot Water, page 15).
Troub
Possib
Brewer
Brewer
Note
Coffee
or wate
There a
from 13
on K-Cu
Custom
www.br