Operating Your Breville Gourmet Single Cup Brewer; Installing The Water Filter - Breville BKC600XL User Manual

BR9013 BKC600XL_IB_AMEND.qxp

Operating your Breville Gourmet Single Cup Brewer

Installing the water filter

For the best tasting gourmet coffee, tea or hot cocoa,
Breville recommends using bottled or filtered water.
The Water Filter provided with the Brewer can
significantly reduce substances that affect the smell
and taste of water such as free chlorine, certain
pesticides and organic impurities as well as traces of
heavy metals.
The Water Filter can be removed from the Brewer.
If you choose to install the Water Filter, it is
recommended to replace the Charcoal Filter
every 2 months or 60 tank refills, more often if
you have hard water.
We recommend removing the Water Filter if using
filtered water, or if you choose not to replace the
Charcoal Filter every 2 months, as the filter may
clog and affect the smell and taste of the water.
If you choose not to install the Water Filter, you
are ready to start the One-time Priming Process
(page 9).
Follow these steps each time you install a new
Charcoal Filter to ensure it filters optimally.
1. Remove the Water Tank from the Brewer by
gripping the handle located on the left side of the
Water Tank, then lift upwards.
8
11/10/07 21:43 Page 8
2. Remove the Water Tank Lid.
3. Rinse the Water Tank with fresh water and
replace back onto the Brewer.
4. Remove the Upper and Lower Filter Holder and
Charcoal Filter from the polybag. Unwrap the
Charcoal Filter from its protective plastic.
5. Soak the Charcoal Filter for 5 minutes then rinse
for 30 seconds. It is normal to see a grey residue
after soaking the filter.
6. Wash the Lower Filter Holder, ensuring the
stainless steel mesh is free of residue.
7. Insert the Charcoal Filter into the Upper Filter
Holder, then attach the Lower Filter Holder so it
locks into place.
Note
8. Set the date dial on the Upper Filter Holder
2 months ahead. This will remind you when the
Charcoal Filter will need to be replaced.
9. Place the assembled Filter Holder into the Water
Tank, aligning so the date dial is visible from
outside the Tank. Push down hard on the
assembled Filter Holder until it snaps into place.
10. Your Brewer is ready for the one-time
priming process.
™
Replace
60 tank
To order
Breville
visit ww
We reco
choose n
2 month
smell an
One-tim
Priming fil
the brewin
it has been
If the Br
below fr
hours to
A frozen
properly
1. Unwra
into a
2. Place
drip tr
accom
3. Fill the
approx
The W
a)
b)