Connect The Inlet Hoses - Kenmore Extra Large Capacity Plus LAUNDRY CENTER Use And Care Manual

For laundry tub or standpipe drain system
Connecting the drain hose "hook" to the corrugated drain hose
1. Wet the outside end of the drain hose with tap water. Do not
use any other lubricant.
2. Twist and push the "hook" back and forth while pushing
down onto the drain hose. Continue until the "hook" is down
to the enlarged diameter of the drain hose.
1. Hooked end
2. Drain hose
3. Open the yellow single-wire clamp and slide over the end of
the drain hose "hook" to secure the sections together. (Pliers
optional.)
4. Put hooked end of drain hose into laundry tub or standpipe.
Rotate "hook" to eliminate kinks.
To prevent drain water from going back into the washer:
• Do not straighten hooked end of the drain hose and force
excess drain hose into standpipe. Hose should be secure but
loose enough to provide a gap for air.
• Do not lay excess hose on the bottom of the laundry tub.
For use with floor drain
Do notinstall the drain hose "hook" on to the corrugated drain
hose, You may need additional parts (see Floor Drain under
"Alternate Parts You May Need").
1.
Csnnect,,: q ® n® bksses
Insert a new flat washer (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
¢ 2
1. Coupling
2. Washer
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hose with the red coupling to the hot water faucet.
Screw on coupling by hand until seated on the washer.
3. Attach the hose with the blue coupling to the cold water
faucet. Screw on coupling by hand until seated on the
washer.
4. Using pliers, tighten the couplings with an additional two-
thirds turn. Do not overtighten. Damage to the valves can
result.
Clear the water lines
5. Run water through both faucets and inlet hoses, into a bucket
or laundry tub, to get rid of particles in the water lines that
might clog the inlet valve screens.
Connect the inlet hoses to the washer
6. Attach the hose with the blue coupling to the cold water (top)
inlet valve. Screw on coupling by hand until seated on the
washer.
7.
8.
1. Cold water inlet valve (blue)
2. Hot water inlet valve (red)
Attach the hose with the red coupling to the hot water
(bottom) inlet valve. Screw on coupling by hand until seated
on the washer.
Using pliers, tighten the couplings with an additional two-
thirds turn. Do not overtighten. Damage to the valves can
result.
14