Install Leveling Legs - Kenmore Elite 27-Inch Wide GAS DRYERS Owner's Manual And Installation Instructions

B. INSTALL LEVELING LEGS
Leveling your dryer correctly will
reduce operating noise and provide
improved drying performance.
STEP 4. Start to screw the legs into the
holes by hand. Use a wrench to finish
turning the legs until diamond marking
is no tonger visible. This is when we
recommend you start checking the dryer
for levelness. Further adjustment may
be necessary.
STEP !. Take two of the cardboard
corners from the carton. PIace them
on the floor in back of the dryer.
STEP 2. Firmly grasp the body of the
dryer (not the top or console panel).
Gently lay dryer on the cardboard
corners.
STEP 3. With one of the legs in hand,
check the ridges for a diamond marking.
STEP 5. Stand the dryer up and move
it cIose to its final location. Leave enough
room to connect the exhaust vent.
STEP 6. Check levelness of dryer by
pIacing a level on top of the dryer, first
side-to-side then front-to-back.
STEP 7. If dryer is not level, prop the
dryer up using two stacked cardboard
corner posts. Use a wrench to adjust the
legs up or down.
14
NOTE: It may be necessary to level the
dryer again after it is moved into its final
position.