Preparing For Installation; Make Sure Your Computer Is Ready; Take Antistatic Precautions - Intergraph Intense 3D Pro 2200 Installation Manual

2

Preparing for Installation

Follow these instructions to prepare your computer for Intense 3D Pro
2200.

Make Sure Your Computer Is Ready

Make sure your IBM PC-compatible computer has the following:
u
A Pentium, Pentium Pro, or Pentium II processor.
u
A high-resolution multi-sync analog RGB monitor.
u
Windows NT 4.0 operating system.
u
A BIOS that supports PCI-to-PCI bridges.
u
3 MB of free space on the computer's hard disk.
u
Open PCI expansion slots that support PCI bus mastering, one for
each board you want to install.
u
A power supply that provides +3.3V to the PCI bus.

Take Antistatic Precautions

Static electricity can damage the components inside a computer or on
a printed circuit board. To keep the possibility of electrostatic
discharge to a minimum, do the following:
u
Turn off power to the computer.
u
Touch the metal chassis of the computer to drain off any static
electricity before touching a board.
u
Wear a properly connected grounding wrist strap when handling a
board or working in a computer.
u
Do not wear wool or polyester clothing.
u
Work in an area with a relative humidity of at least 50 percent.
u
Do not remove a board from its antistatic bag until you are ready
to install it.
u
Handle a board as little as possible and by the edges only.
3