Picking Up Bobbin Thread - White ET-6/10 Instruction Manual

PCKNG UP BOBBIN THREAD
Raise the presser foot lever.
2. Holding the top thread loosely in the left
hand, turn the hand wheel towards you
with your right hand and bring the needle
to its nignest position.
3. Lightly pulling the top thread, pick up the
bobbin thread appearing through the
needle plate slot.
4. Pull
both
top
and
bobbin threads
together, passing under the presser foot
towards the rear of the machine, leaving
about 6" (15 cm) clear.
If you cannot pick up the bobbin thread by
following the above steps,
check the
following points.
1. Is the needle correctly threaded ?
2. Is the thread tangled around the needle?
3. Is there about 6" (15 cm)of thread com
ing out from the bobbin case?
4. is the thread from bobbin case tangled?