Pre-Assembly - Spirit XT185 Owner's Manual

Assembly Video
To assist you in assembling your new Spirit Fitness treadmill, we have posted an assembly video at the following link:
http://www.spiritfitness.com/customerservice/video/treadmillvideos.html

Pre-Assembly

Please read before unpacking your folding treadmill. Serious injury could occur if this folding treadmill
is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from unfolding accidentally
during shipping. If this strap is not removed properly the treadmill could spring open unexpectedly and cause injury if
someone is standing near the treadmill when the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the treadmill is positioned flat
on the ground, in the orientation it would be in if you were using the treadmill. Do not turn the treadmill up on its
side while removing the shipping strap. This could cause the treadmill's folding mechanism to spring open. If the end
of the Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck, reach under the
deck to grab it, but do not tilt the treadmill up to gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from the one underneath it by
prying up on the staples (if applicable). Pull the carton over the treadmill parts and locate the hardware pack. The
hardware pack is separated into five sections; one section containing tools and four sections labeled steps 1-4 which
contain the hardware needed for assembly of each step. The assembly steps below are numbered one through four
and correspond to the hardware in the numbered sections of the hardware pack. Remove only the hardware for the
step you are currently assembling to avoid confusion and mix ups.
Then remove the treadmill from the carton and lay it on a level surface.
Assembly T ools
#96. Combination M5 Allen Wrench/
Phillips Head Screw Driver
#97. M6 Allen
Wrench
#122. Phillips Head Screw Driver
#33. Safety Key
5
#58. Deck/Belt
Lubricant
XT185
T readmill