iSimple ConnectGM Owner's Manual page 9

8. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfac-
tion. This warranty applies only to the original purchaser of this product from an autho-
rized iSimple ® dealer. This warranty covers any supplied or manufactured parts of this
product that, upon inspection by iSimple
in normal use due to defects in material or workmanship. This warranty does not apply
to installation expenses. Attempting to service or modify this unit, operating this unit
under conditions other than the recommended voltage will render this WARRANTY
VOID.
Unless otherwise prescribed by law, iSimple
property damage and or any incidental or consequential damages of any kind (includ-
ing water damage) resulting from malfunctions, defects, misuse, improper installation
or alteration of this product. All parts of this iSimple
period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above,
iSimple ® will repair or replace the product at their discretion, if it is defective in material
or workmanship providing it is returned to an Authorized iSimple
OF PURCHASE from an authorized iSimple
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modifications not expressly approved by the party responsible
for compliance could void the user authority to operate the equipment.
®
authorized personnel, is found to have failed
®
shall not be liable for any personal injury,
®
product are guaranteed for a
®
dealer.
®
dealer, with PROOF
7