Back Angle Adjustment - Invacare Pronto R2 Series Servise Manual

SEAT/BACK

BACK ANGLE ADJUSTMENT

(FIGURE 8)
1. Remove armrests from the wheelchair. Refer to IN-
STALLING/REMOVING FLIP BACK ARMRESTS in
PROCEDURE 4 of the Owner's Manual, part num-
ber 1095206.
2. Remove the mounting screw and washer from the top
mounting hole of back angle plate and back cane.
NOTE: To avoid losing the insert in each back cane, thread
the mounting screw through the cane from the inside of
wheelchair to hold the insert in place.
TO ACHIEVE A BACK ANGLE OF:
ANGLE BACK CANE MOUNTING HOLE
80 O
O
85
90 O
95 O
O
100
Top
Bottom
Top
2nd from Bottom
Top
Bottom
Top
2nd from Bottom
Top
Bottom
FIGURE 8 - BACK ANGLE ADJUSTMENT
21
3. Remove the mounting screw and washer from the
bottom mounting hole of the back angle plate and
back cane.
4. Reposition the back canes into the correct mounting
holes of the back angle plate to obtain a back angle
o
between 80 and 100
5. Torque mounting screws to 75-inch pounds.
6. Reinstall the armrests onto the wheelchair. Refer to
INSTALLING/REMOVING FLIP BACK ARMRESTS
in PROCEDURE 4 of the Owner's Manual, part num-
ber 1095206.
BACK ANGLE PLATE HOLE
BOTTOM Rear
BOTTOM Center
BOTTOM Front
TOP Center
BOTTOM Front
BOTTOM Front
PROCEDURE 6
o o
in 5 increments.
TOP Front
TOP Front
TOP Front
TOP Rear
S
E
A
T
/
B
A
C
K