Invacare Pronto R2 Series Servise Manual page 31

WHEELS
10. Position the caster into the new fork.
11. Reinstall the hex screw, washers and locknut that
secure the caster to the new fork.
12. Torque the locknut to 120-inch pounds.
13. Loosen the locknut 1/8 of a turn.
14. Move the caster side to side.
NOTE: If the caster moves side to side, tighten the
locknut slightly. Repeat STEP 14 until there is no side
to side movement of the caster.
15. Adjust the fork. Refer to ADJUSTING FORKS in
PROCEDURE 8 of the Owner's Manual, part num-
ber 1095602.
Dust Cover
Locknut
Nylon Washer
Fork
Hex Screw
Washer
FIGURE 5 - REPLACING FORKS
31
PROCEDURE 9
Caster Headtube
Locknut
Washer
Caster
W
H
E
E
L
S