Weekly Parts Washing - Bunn SLCA-7 Installation & Operating Manual

Weekly: Parts Washing and Sanitizing
1. Remove elbows from 2. Remove elbows from
both hoppers.
6. Remove mixing
7. Remove middle and
chambers by pulling
straight out.
12. Prepare
11. Clean all parts re-
moved in warm soapy
water. Use Bunn P/N
33685.0000 clean-
ing brush provided
to clean bores and
orifices. Rinse in cold
water.
3. Remove
middle and right mix-
hose from left whip-
ing chambers, twist- ping
ing slightly to help sliding it to the right.
release.
8. Remove left frother
right frother disk
from shaft by pulling
from shaft by pulling
straight out.
straight out.
one-gallon 13. Rinse
(3.8 liter) of sanitiz-
ing solution with at
least 100 ppm of
available chlorine in
120°F (48.9°C) wa-
ter.Soak all cleaned NOTE: Repeat this pro-
parts in sanitizing so- cedure for each nozzle
lution for 5 minutes, separately.
then rinse thoroughly
in cold water, and
dry.
dispense 4. Remove upper mix-
ing bowl from left
chamber by pulling
chamber by
out and up.
9. Rotate tab on mix-
ing chamber base
further counter clock
wise, and remover
from shaft by pulling
straight out.
NOTE: Insure O-ring and
shaft seal are in place
during re-assembly.
cleaning 14. When
brush, dip in sani- bling parts, be sure
tizing solution, and to align arrow on
brush the bore of frother
each of four dis- flat on whipper mo-
pense nozzles. tor shaft, and rotate
tab on whipper base
clock wise to the
vertical position to
lock mixing cham-
ber.
16
5. Rotate tab at bottom
of mixing chamber
bases counter clock
wise to release base.
10. Remove
hoses from dispense
nozzle assembly.
reassem-
15. When reassembling
left frother, be sure
to align raised bar
disk with on top of frother
shaft with the flat
on whipper motor
shaft.
dispense
39328.3 012113