Warming Shelves Installation; Glass Replacement - Heat & Glo TIARA I-B Owner's Manual

N. Warming Shelves Installation
TOOLS REQUIRED: Phillips head screwdriver.
KIT CONTENTS: (2) Warming shelves, (2) brackets, and (4)
1/4 in. (Phillip head screws.
Figure 8.33 Remove warming shelves and hardware from
packaging. Install leveling screw to each warming shelf.
Figure 8.34 Install warming shelf bracket loosely to each
warming shelf using the screw provided.
Figure 8.35 Gently lift cast top off of appliance and set aside.
Install warming shelf to appliance gently aligning the shelf
with the tabs that are in place on the side of the appliance.
Use the leveling screw located in the center of the warming
shelf to adjust the shelf to its desired position.
August 1, 2008
Figure 8.36
screw to hold it in place. Reassemble the appliance.
O. Glass Replacement
1.
2.
3.
4.
5.
Heat & Glo · Tiara I B & Tiara II B · 7010-149M
Align bracket to fi rebox and gently tighten the
Turn appliance OFF and let cool down before replacing
the glass.
Remove the front by lifting upwards 1/2 in. (13mm) and
away from the appliance.
Tiara I-B: Remove the glass door by opening the latches
located on both the left and right sides at the bottom of
the glass. Pull towards you and separate latches from
notches.
Tiara II-B: Remove the glass door by opening the
latches located on both the left and right sides at the
top of the glass. Pull towards you and separate latches
from notches. Lift the glass out of the two notches at its
bottom and carefully set aside.
The new glass will come installed in a new glass frame.
Installation of the new glass and frame is the opposite
of the removal.
Reinstall appliance front.
CAUTION
Handle glass assembly with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.
Page 37