Introduction - Advantech SBD75e Series Installation And Operation Manual

Front Panel Monitoring & Control

Introduction

3.1
The SBD75e Demodulator is equipped with an active front panel (LCD screen and keypad)
which provides an easy way to setup the Demodulator without the need for a PC or generic
control system. This chapter is intended to allow maintenance personnel or users to quickly set up
the Demodulator for initial use.
Switch On
Advantech AMT
TM
Press any key to continue.....
Overview :
Select Board >
Chassis Info >
Set Brightness :
Chassis Info >
Set Brightness :
3-2
(para. 5.3.1)
(para. 5.3.2)
(para. 5.3.3)
(para. 5.3.4)
Overview :
Select Board >
Status > (para. 5.3.2.1)
Est. SNR :
Actual Baud Rate :
Est. Signal Power :
Demod Freq :
Prog Baud Rate :
Prog Bit Rate :
Actual Bit Rate :
Spectrum:
Est. EBNO:
Est. BER :
BERT BER :
Status (para. 5.3.2.1.1)
FPGA :
Signal Level :
AGC :
Timing :
Carrier :
SDF :
Coding :
ALL :
Configure > (para. 5.3.2.2)
Profiles >
Load Profile >
Create Profile >
Delete Profile >
Inputs > (para. 5.3.2.2.2)
Input :
LNB Power :
LNB Polarization :
LNB 22KHz :
Spectrum :
Alpha :
Search Range :
Search Step :
Spectral Analysis :
Coding > (para. 5.3.2.2.3)
DVB
DVB_SNG
DVB-S2S
DVB-S2N
Intelsat
Modulation :
Data Rate :
Frequency :
Freq Offset :
Descrambler :
Pilots :
Outer RS :
Diff. Decoding :
Equalizer :
Remove Mark :
Unframed ASI :
PLS Seed :
Output X ISI :
Output X Mode :
Reconfigure :
System Setup >
SBD75e Series Demodulator Installation and Operation Manual
(para. 5.3.2.2.1)