Table of Contents
Advertisement
S pecification s
A.1 Resetting FastPort Back to the Factory Defaults
1. Place the front panel switches: D3 and D4 down.
2. Unplug then plug back in the power supply.
3. Wait at least 4 seconds.
4. Toggle switch D4 up and down quickly at least 10 times.
If the reset is successful, SER (serial) LED will blink once.
5. Reset switch D4 back to default (up).
6. Set switch D4 down for printing only (no telnet).
7. Power cycle the unit.
A.2 Hardware Features
• The MIL-3000FTX motherboard, with Ethernet controller,
serial, and parallel port interfaces
• CPU: An 80186 processor, with a 16 MHz clock
• Memory: 256K RAM
MIL-3000FTX Series of FastPort Print Servers
A p p e n d i x A
S
P
E
C
I
F
I
C
A
T
I
O
N
S
A-1
Advertisement
Table of Contents
