Installing Fastport - Digi FastPort MIL-3100FTX User Manual

Chapter 2

2.2 Installing FastPort

I
N
S
T
A
L
L
A
T
I
O
N
D 3 D 4
Up Up
Down Up
Down Down
Up Down
Note: The MIL-3200FTX will have one extra LED: "P2." The MIL-3310FTX will
2-2
To install a MIL-3000FTX FastPort print server:
1. Attach the Rubber feet to the bottom of the print server.
Place one on each corner of the device.
2. Record the Ethernet address (located on the bottom of the
unit) for future reference.
3. Attach the Ethernet cabling: The MIL-3000FTX supports
10/100BASE-TX cabling and has an RJ-45 connector. Use
CAT 5 (UTP).
4. Select an operating mode with the front panel switches.
Use Table 2-1.
T a b l e 2 - 1 : Operating Mode
Mode
Normal Does not allow a telnet session. Users can print to the unit. The
SYS (system) and NET (network) LEDs blinks.
Telnet Allows a telnet session to monitor FastPort or change its
diagnostic parameters. Users can print to the unit. The SYS and NET LEDs
monitor blink.
Serial A terminal can be attached to the serial port to run a serial
diagnostic monitor. Print jobs are not accepted. The NET LED blinks.
monitor
Test page A test page prints on a power cycle. Print jobs are not accepted.
10/100
MIL•3100FTX
FastPort 10/100 Mb/s
PRINT SERVER
Figure 2-1. MIL-3100FTX Front Panel
have two extra LEDs: "P2" and "P3."
Description
Front
RX TX P1
SWITCH
1
LNK NET SYS SER PWR
MIL-3000FTX Series of FastPort Print Servers
SERIAL
2 3 4