Connection And Operation; Inspection; Connection - Mustek PowerMust 1000 On Line(1K) User Manual

Connection and Operation

4.
The system may be installed and wired only by qualified electricians in accordance with
applicable safety regulations!
When installing the electrical wiring, please note the nominal amperage of your incoming
feeder.

4.1 Inspection

Inspect the packaging carton and its contents for damage. Please inform the transport
agency immediately should you find signs of damage.
Please keep the packaging in a safe place for future use.
NOTE: Please ensure that the incoming feeder is isolated and secured to prevent it from
being switched back on again.

4.2 Connection

4.2.1 UPS Input Connection
If the UPS is connected via the power cord, please use a proper socket with protection
against electric current, and pay attention to the capacity of the socket: over 10A for
1K(S) & 2K, over 16A for 2KS& 3K(S).
4.2.2 UPS Output Connection
The output of 1K(S) and 2KS(Non CE) are socket-types only. Simply plug the load
power cord to the output sockets to complete connection.
Model No.
1K/1KS
2K
2KS
3K/3KS
Besides output sockets,2KS(CE) and 3K/3KS has the terminal block available for output
as well.The wiring configuration is shown as the following procedure:
(1) Remove the small cover of the terminal block
(2) Use AWG14 or 2.1mm
Output Socket
(pcs)
4
6
4(CE) 6(Non CE)
4(CE) 3(Non CE)
2
wires for wiring configuration
6
Terminal Block
Nil
Nil
Available(CE) Nil (Non CE)
Available