Safety Instructions - Mustek PowerMust 1000 On Line(1K) User Manual

2. Safety Instructions

PLEASE READ THE FOLLOWING USER MANUAL AND THE SAFETY INSTRUCTIONS
BEFORE INSTALLING THE UNIT AND STARTING IT UP!
Transport
· Please transport the UPS system only in the original packaging (to protect against shock
and impact).
Set-up
· Condensation may occur if the UPS system is moved directly from a cold to a warm
environment. The UPS system must be absolutely dry before being installed. Please allow
an acclimatisation time of at least two hours.
· Do not install the UPS system near water or in damp environments.
· Do not install the UPS system where it would be exposed to direct sunlight or near heat.
· Do not block off ventilation openings in the UPS system's housing.
Installation
· Connect the UPS system only to an earthed shockproof socket outlet.
· The building wiring socket outlet (shockproof socket outlet) must be easily accessible and
close to the UPS system.
· Please use only VDE-mark, CE-mark mains cable (e.g. the mains cable of your computer) to
connect the UPS system to the building wiring socket outlet (shockproof socket outlet).
· Please use only VDE-mark, CE-mark power cables to connect the loads to the UPS system.
· Do not connect domestic appliances such as hair dryers to UPS output sockets.
· Do not connect appliances or items of equipment which would overload the UPS system (e.g.
laser printers) to the UPS outlet socket.
· Place cables in such a way that no one can step on or trip over them.
· With the installation of the equipment, it should prevent that the sum of the leakage current
of the UPS and the connected consumer does not exceed 3.5mA.
Operation
· Do not disconnect the mains cable on the UPS system or the building wiring socket outlet
(shockproof socket outlet) during operations since this would cancel the protective earthing
of the UPS system and of all connected loads.
2