ADC PHASE 6 OPL User Manual page 8

P. Reversing Option - helps eliminate wrinkling due to the balling up or tangling of large items. Certain
models have the reversing option where the basket (tumbler) will turn in the forward direction for 2 minutes,
stop for 5-seconds, and then proceed in the reverse direction for 2 minutes. This process is repeated
throughout the drying and cooling cycles.
Q. Rotation Sensor Selection - this feature allows the Phase 6 OPL microprocessor controller (computer)
to monitor the rotation of the basket (tumbler). If the basket (tumbler) should fail to rotate, the Phase 6
OPL microprocessor controller (computer) will disable ALL outputs, stopping the dryer and a failure code
will be displayed on the light emitting diode (L.E.D.).
R. RPM - Phase 6 microprocessor control (computer) also displays basket (tumbler) RPM by pressing the
"ENTER/START"
RPM will be displayed. (Rotational Sensor must be active for this RPM Features).
S. Clean Lint - this routine monitors the response of the "Lint Count" register. The register contains the
acceptable limit of dryer cycles the dryer will be allow to operate before the microprocessor locks the user
out. This routine will first prompt the user to "REAdY CLEAN LINT" two (2) cycles prior to locking out.
Once the routine prompts the user "CLEAN LINT" the dryer is now in a locked state and will not be
cleared until the Lint Drawer has been cleaned. Once the Lint Drawer has been opened the display will
read "LINT dOOR" and when the Lint Drawer has been closed, the display will read "REAdY." The
dryer circuit is now active and can be programmed.
Key and releasing it then press the "ENTER/START"
5
Key and holding the tumbler