Timed (Manual) Drying Cycle (Mode); Temperature Selections (Drying Temperatures) - ADC PHASE 6 OPL User Manual

On-premise laundry (opl) drying system
Table of Contents

Advertisement

The "A" and "B" Factors have been preprogrammed by the factory as outlined on page 51 and page 52 and
SHOULD NOT BE CHANGED unless the Phase 6 0PL microprocessor controller (computer) should fail and
is being replaced. The replacement Phase 6 0PL microprocessor controller (computer) MUST BE
PROGRAMMED for the particular dryer model and heating unit as shown in the "A" and "B" Factor table on
page 56 of this manual.
6. For Optional Reversing Models - the Phase 6 OPL microprocessor controller (computer) can be programmed
to reverse or no reverse (single direction rotation).
7. When used in conjunction with the Preprogrammed Cycles, programming allows the Anti-Wrinkle Program
to be active or non-active.
D. TIMED (MANUAL) DRYING CYCLE (MODE)
This drying cycle is intended for special loads where a specific amount of drying time and cooling time is needed,
especially for fine, delicate items which require very low temperatures and long drying and/or cool down time
periods.
Timed (Manual) Cycle (Mode) Selections:
1. Drying Time - programmable from 0 to 99 minutes in one-minute increments.
2. Cool Down Time - programmable from 0 to 99 minutes in one-minute increments.
3. Drying Temperature - programmable from 100º F to 200º F in one-degree increments or from 37º C to 93º
C in one-degree increments.
4. For optional reversing models, the Phase 6 OPL microprocessor controller (computer) can be programmed
to reverse or no reverse (single detection rotation).
5. When used in conjunction with the preprogrammed cycles, programming allows the Anti-Wrinkle Program
to be active or non-active.
E. TEMPERATURE SELECTIONS (DRYING TEMPERATURES)
Operating Temperature Selections:
1. Automatic Drying Cycle (Mode) (Patent No. 4,827,627) - programmable from 160º to 200º F in
one-degree increments or from 71º C to 93º C in one-degree increments.
2. Timed (Manual) Drying Cycle (Mode) - programmable from 100º F to 200º F in one-degree increments or
from 37º C to 93º C in one-degree increments.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents