Program Location 2; Program Location 5; Program Location 8; Program Location 0 - ADC PHASE 6 OPL User Manual

To enter program mode, press
"ENTER/START"
I
and immediately press the "0" Key
three (3) times within two seconds.
Display will read "COOL" for 1 second and
"TEMP" for 1 second. If no change, press
"ENTER/START" Key. If a change is
I
necessary, enter temperature change (70º
to 100ºF in increments of 1ºF). I.e., for
90ºF, press Key "0", Key "9", Key "0", and
then press "ENTER/START"

Program Location 8

No Cycle In Progress
REAdY
Key once,
PROGRM
8
COOL
TIME
06 M
0
8
08 M
COOL
TEMP
Key.
I
080 F
0 0
Display will read "COOL" for 1 second and
"TEMP" for 1 second. If no change, press
"ENTER/START"
necessary, (0 to 99 minutes in increments of
1 minute). I.e., for 8, press Key "0", Key "8",
and then press "ENTER/START"
0 9
Non-Reversing
Models
Reversing
Models
42
0
Key. If a change is
I
Key.
I
0 090 F
Skip to Continue
on page 45.
Continue