HP BladeSystem c3000 Quickspecs page 33

QuickSpecs
Technical Specifications
Input Requirements Input Requirements
Input Requirements Input Requirements
(per AC power supply)
BTU Rating BTU Rating BTU Rating BTU Rating
Power Specifications Power Specifications Power Specifications Power Specifications
Power Supply Output Power Supply Output Power Supply Output Power Supply Output
(per power supply)
System Inlet Temperature Operating System Inlet Temperature System Inlet Temperature System Inlet Temperature
Relative Humidity Relative Humidity Relative Humidity Relative Humidity
(non-condensing)
Altitude Altitude Altitude Altitude
DA - 12790 North America — Version 7 — February 11, 2008
Rated Line Voltage
Rated Input Current
Rated Input Frequency
Maximum per power
supply
To review typical system power ratings use the Power Calculator which is
available via the online tool located at URL: :
www.hp.com/go/bladesystem/powercalculator
Rated Steady-State Power 800 W (at 100 VAC),
Maximum Peak Power
Non-operating
Operating
Non-operating
Operating
Non-operating
HP BladeSystem c3000 Enclosure HP BladeSystem c3000 Enclosure HP BladeSystem c3000 Enclosure HP BladeSystem c3000 Enclosure
90 – – – – 132 VAC
180 - 264 VAC
9.3 A (at 100 VAC)
9.7 A (at 110 VAC)
7.8 A (at 200 VAC)
7.2 A (at 208 VAC)
6.8 A (at 220 VAC)
6.2 A (at 240 VAC)
47 to 63 Hz
2728 BTU/hr (at 100 VAC)
3069 BTU/hr (at 120VAC)
4092 BTU/hr (at 200 to 240 VAC)
900 W (at 120 VAC)
1200 W (at 200 to 240 VAC)
880 W (at 100 VAC),
990 W (at 120 VAC)
1350 W (at 200 to 240 VAC)
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change is
10°C/hr (18°F/hr). The upper limit may be
limited by the type and number of options
installed. System performance may be reduced if
operating with a fan fault or above 30°C (86°F).
-30° to 60°C (-22° to 140°F). Maximum rate of
change is 20°C/hr (36°F/hr).
10 to 90% relative humidity (Rh), 28°C (82.4°F)
maximum wet bulb temperature, non-
condensing.
5 to 95% relative humidity (Rh), 38.7°C
(101.7°F) maximum wet bulb temperature, non-
condensing.
3050 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 457
m/min (1500 ft/min).
9144 m (30,000 ft). Maximum allowable
altitude change rate is 457 m/min (1500 ft/min).
Page 33