Ford Crown Victoria 2011 Owner's Manual page 274

Crown Victoria Severe Duty
Pin Function
6 50A Battery
7 20A Run/Acc
8 10A Run/Acc
9 50A Battery
10 Not used
11 50A Battery
12 10A Run/Acc
The mating connector is provided on the end of the power distribution
connector. The vehicle modifier can either purchase pins for the mating
connector and install them on the wires before they are inserted into the
connector, thereby avoiding any splicing, or purchase an optional power
pigtail for the interface. The power pigtail (P/N 14A411) plugs into the
power distribution connector and provides blunt cut wires ready for
splicing by the vehicle modifier.
See the Police Interceptor Modifier Guide for more details.
Rear power point - police
The rear power point is a battery access port for police auxiliary
equipment mounted in the trunk. It is capable of supplying 80 amps of
battery power. The front power distribution box (PDB) contains two
50 amp fuses, which protect the power point. Battery access is via two
studs contained in an enclosure, mounted in the trunk, on the right side
fender support. The terminal with the red wires is the battery positive,
and the terminal with the black wire is the ground. Remove both fuses in
the front PDB before removing the cover to the rear power point. Ensure
load devices can be turned off, and are switched off when reinserting
fuses.
WARNING: Under no circumstance should the rear power point
cover be removed without first pulling the two fuses in the front
power distribution box. Removing cover without pulling fuses could
result in an electrical hazard, and result in personal injury. Shut off
load devices before inserting fuses.
274
2011 Crown Victoria (cro)
Owners Guide, 3rd Printing
USA (fus)
Taxi
Gauge Color
10 Tan/Yellow
12 White/Pink
14 Light Blue/White
10 Yellow
—
10 Red/White
14 Gray/White
—