Install The Remote Cover Plate - Heatilator Direct Vent Gas Appliance CNXT4236IH Owner's Manual

H. Install the Remote Cover Plate
The remote cover plate shipped in the bottom of the
appliance MUST be placed over the control plate before
operating the appliance. Not doing so may result in over-
heating the controls on the plate.
Install the Cover Plate
• Locate cover plate (see Figure 12.4) and remove from
appliance.
Figure 12.4 Remote Cover Plate - Shipping Location
• Bend four legs at 90° angle.
Figure 12.5 Bend Legs
56 Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08
• Place over control plate so that all of the control plate is
covered and legs are on bottom pan of appliance. See
Figures 12.6 and 12.7.
Figure 12.6 Placing Remote Cover Plate
Figure 12.7 Remote Cover Plate - In Place
• Make sure all wires are under the top of the cover plate
and that there are no wires pinched between legs and
the bottom pan.