Table of Contents
Advertisement
10
10
Electrical Information
A. Electronic Ignition System Wiring
• This gas appliance is equipped with an electronic ignition
system which operates on a 6 volt system.
• The batteries are located within the ignition module which
is located under the unit. A wiring diagram is shown in
Figure 7.1.
• The battery pack requires four AA batteries (not
included).
CAUTION
Battery polarity must be correct or module damage will
occur.
PILOT
Figure 10.1 Electronic Ignition Wiring Diagram
IGNITION MODULE
6VDC
BATTERY PORT
(4 AA BATTERIES)
ON/OFF
SWITCH
Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07
Shock hazard.
• Replace damaged wire with type 105º C rated wire.
• Wire must have high temperature insulation.
CAUTION
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
FLAME SPARKER/
SENSOR
PILOT GAS LINE
CONNECTED TO
BACK OF VALVE
WARNING
VALVE
REMOTE
CONTROL
ANT.
ON/OFF
WALL SWITCH
IGNITION
MODULE
(6V)
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
23
Advertisement
Table of Contents
