Replacing The Power Supply Assembly - Lenovo 3376 Maintenance Manual

Replacing the power supply assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the power supply assembly.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 81.
3. Disconnect the power supply assembly cables from all drives and from the 14-pin power connector and
4-pin power connector on the system board. See "Locating parts on the system board" on page 72.
.
Chapter 9 Replacing FRUs (machine types: 3376, 3378, and 3387)
95