Table of Contents
Advertisement
17. Install all memory modules and PCI cards removed from the failing system board on the new system
board. See "Installing or replacing a memory module" on page 87 and "Installing or replacing a PCI
card" on page 84.
18. Reconnect all remaining cables to the system board. See "Locating parts on the system board"
on page 72.
19. To complete the replacement, go to "Completing the parts replacement" on page 116.
The failing system board must be returned with a microprocessor socket cover to protect the pins during
shipping and handling.
To install the microprocessor socket cover, do the following:
1. Release the lever securing the microprocessor retainer and open the retainer to access the
microprocessor.
2. Grasp the microprocessor on the sides and lift it straight up and out of the socket. Do not touch the
contacts on the microprocessor socket.
3. Note the orientation of the socket cover. Align the notches
the alignment keys
4. Install one side of the socket cover into the microprocessor socket as shown.
Figure 35. Installing the socket cover
Note: Your microprocessor socket and cover might look slightly different from the illustration.
2
of the microprocessor socket.
Chapter 9
1
of the microprocessor socket cover with
.
Replacing FRUs (machine types: 3376, 3378, and 3387)
103
Advertisement
Table of Contents
Troubleshooting
